Skip to main content
× Home Services Products Catalogs Downloads Tech Support About Contact Careers (505) 872-0037

(505) 872-0037

Shopping Cart Icon
cart
 
Login Icon
login
Ideal Vacuum Cube Sales Ideal Vacuum Command Valves Helium Leak Detectors On Sale New Scroll Pumps Agilent Helium Leak Detectors on Sale Turbo Pumps on Sale

Keyword       Ideal Vacuum Part Number       Manufacturer Part Number

× Vacuum Pumps Modular Vacuum Chambers Welded Vacuum Chambers Vacuum Chamber Systems Fittings and Flanges Feedthroughs Vacuum Valves Turbo Pump Systems Rebuild Kits, Parts, And Motors Vacuum Fluids, Oils, and Grease Filters Traps and Silencers Vacuum Ovens Gas and Leak Detection Gauges And Controllers Pressure Measurement Chillers
Product Image 1
Product Image 2
Product Image 3

Condition:
  New
Part Number:
  P104617
Warranty:
  Varian Warranty

Available Now: 1   Agilent Varian ConvecTorr Convection PType Gauge Simulator and Reference Tube, L7382301 418.75


$418.75


Print Version

Agilent Varian ConvecTorr Convection PType Gauge Simulator and Reference Tube, L7382301


Agilent Varian ConvecTorr Convection-PType Gauge Simulator and Reference Tube,
Agilent pn: L7382301


Description:
The Convectorr Simulator (L7382-301 P type) is intended to be a convenient tool for verifying proper operation of the MultiGauge, SennTorr or XGS-600 control units. For those cases when the target gauge tube can not be brought to proper pressure levels for true in-situ calibration, the simulator can be used to at least insure the control unit is calibrated to the average tube.

Operation:
Normally, the simulator would be plugged into the target gauge cable at the sensor end. When the switch is set to ATM the controller should read approximately 1 x 105 Pa (760 Torr, 1000mBar). If desired, the controller may be "calibrated" by pressing the (ATM) button on MultiGauge or the (CAL) button on SenTorr or CAL on main screen on the XGS-600. Sliding the switch to VAC should cause the controller to read approximately 1.33 x 10-1 Pa (1 mT, 1.3 x 10-3 mBar). Again, the controller may be "calibrated" by pressing the appropriate button on the controller keypad.

NOTE: The Simulator is not intended to take the place of NIST-traceable calibration. The product is intended to verify the functionality of control electronics. For those situations requiring NIST-traceable calibration, Agilent Varian offers the comprehensive STARRS P Program.

Can be used with the following controllers:

  • Varian Multi-Gauge Controller
  • Varian Senn Torr Gauge Controller
  • Varian XGS 600 Gauge Controller

This is a Separate ConvecTorr Gauge Simulator Only, Cables and Controllers available on this website.



Press ESC to Close


Agilent XGS-600 pressure gauge controller
PDF Logo Varian ConvecTorr Gauge Spec Sheet .pdf

PDF Logo Varian Agilent Vacuum Measurement Brochure .pdf

PDF Logo Varian Agilent Convectron Gauge Transducer Pin Outs.pdf



You may wish to consider the following products:

Ideal Vacuum Logo Water Mark
CONTACT US
Ideal Vacuum Products, LLC
5910 Midway Park Blvd NE,
Albuquerque, NM 87109-5805

Phone: (505) 872-0037
Fax: (505) 872-9001
info@idealvac.com



Press ESC to Close


deepbox image 2