Agilent Varian HS-32 Diffusion Pump With Halo Baffle Cold Cap Inlet flange 32 in. ASA, foreline flange 6 in. ASA, 3 Phase, 240 VAC.
Maximum Pumping Speed of 17,300 l/s Air, 21,625 l/s Helium
These Varian Agilent High Throughput models include the series HS-16, HS-20, HS-32 and NHS-35. This is the HS-32 diffusion high throughput vacuum pump. They are the primary industrial standard for high vacuum pumping mechanism. The Agilent Varian HS-32 diffusion pumps have a high pumping speed for all gases and low cost per unit pumping speed when compared with other types of pump used in the same vacuum range. The full fractionating design allows vaporized fluid to be fractionated in the boiler and jet assembly. Contamination and decomposition products are pumped away and only the purest vapor reaches the top jet, assuring highest speed and lowest backstreaming. The vacuum fluid heater is mounted at the bottom of the pump body. The HS pumps have a fill and drain assembly for easy maintenance of pump fluid and continuous monitoring with thermal protection switches. Finned boilers increase the surface area which prolongs fluid life. The inlet is at the top, and the exhaust is through the foreline. The Halo Baffle stops backstreaming as effectively as an optically dense baffle, yet it retains 60% of the pump’s speed.
Highlights For This Agilent Varian HS-32 Diffusion Pump
Diffusion pumps use a high-speed jet of vapor to direct gas molecules in the pump throat down into the bottom of the pump and out the exhaust. The oil diffusion pump is operated with an oil that has low vapor pressure. Its purpose is to achieve higher vacuum (lower pressure) than possible by use of positive displacement pumps alone. Although its use has been mainly associated within the high vacuum range (down to 10-9 Torr), diffusion pumps today can produce pressures approaching 10-10 Torr when properly used with modern fluids and accessories. The features that make the diffusion pump attractive for high and ultra-high vacuum use are its high pumping speed for all gases and low cost per unit pumping speed when compared with other types of pump used in the same vacuum range. Diffusion pumps cannot discharge directly into the atmosphere, so a mechanical forepump is typically used to maintain an outlet pressure around 1 mTorr.
These Varian model HS-32 high vacuum, high throughput diffusion pumps are new and can be ordered with either a 3-phase 240, 415 or 480 VAC heaters. When ordering please specify which voltage your application will require. We stock and sell diffusion pumps oils, along with vacuum fittings, adapters, and replacement parts for your Agilent Varian HS-32 diffusion pumps. This pump uses IVP 704 diffusion pump fluid and is designed for high vacuum and fast pumping of large volumes of gas or vapor in production operations.
For HS-32 Instruction Manual scroll down to manuals tab AVAILABLE DOWNLOADS: and download the .pdf.
- ASA 32 in. Inlet Flange, OD 38.12 in., ID 32.06 in., (16 bolt holes) hole size 0.87 in.
- ASA 6 in. Outlet Flange, OD 11 in., ID 6.73 in., (8 bolt holes) hole size 0.88 in.
- HALO Baffle Cold Cap
- Maximum Pumping Speed 17,300 l/s Air, 21,625 l/s Helium,
- 240 VAC @ 4000 Watt Heater (6 required)
- Weight 1500 lbs. (680Kg) Height 69 in. (1740mm)
- Designed To Be Used With IVP 704 Diffusion Pump Oil (3 U.S. Gallons)