Skip to main content
× Home Services Products Catalogs Downloads TechSupport About Contact Careers (505) 872-0037

(505) 872-0037

Shopping Cart Icon
Cart
 
Login Icon
Login
Language Selector
en-us
×
Americas
Europe
Middle East & Africa
Asia Pacific & Japan
Agilent IDP-10 Dry Scroll Vacuum Pumps On Sale Agilent Varian Helium Leak Detectors On Sale Ideal Vacuum XGC-320 Portable Digital Thermocouple Controllers On Sale Pfeiffer ASM340 Leak Detectors On Sale Agilent IDP-7 Dry Scroll Vacuum Pumps On Sale Agilent IDP-15 Dry Scroll Vacuum Pumps On Sale

Keyword       Part Number:      

× Vacuum Pumps Modular Vacuum Chambers Stainless Steel Vacuum Chambers Aluminum Vacuum Chambers ExploraVAC Unlimited Chambers ExploraVAC TVAC Test Chambers Fittings and Flanges Feedthroughs Vacuum Valves Rebuild Kits, Parts, And Motors Vacuum Fluids, Oils, and Greases Turbo Pumps And Controllers Filters Traps and Silencers Convection and Vacuum Ovens Leak Detection and RGA Vacuum Pressure Measurement Recirculating Chillers And Water Baths
×

Load

Product Image 1
Product Image 2
Product Image 3

Edwards nXDS Exhuast And Gas Ballast Kit, For Minor Rebuild Service, Fits All nXDS Series Pumps, PN: A735-01-803

Print Version
Condition:
  New
Part Number:
  P1011279
Warranty:
  Edwards Warranty

Available Now   4  

Sale: $156.28

Edwards nXDS Exhuast And Gas Ballast Kit, For Minor Rebuild Service, Fits All nXDS Series Pumps, PN: A735-01-803 156.28
Currency: US Dollar (USD)

Description

Edwards nXDS Exhuast And Gas Ballast Kit, For Minor Rebuild Service, Fits All nXDS Series Pumps.
Edwards Vacuum Part Number PN: A735-01-803.

These Edwards nXDS series dry scroll pump exhaust valve and gas ballast kits are often used when a minor rebuild service is required. This is typically needed 2-years after the pump is placed into service, often required between 12,000 and 16,000 operating hours. They are often installed at the same time when the tip seals are being replaced, see Edwards tip seal kit part number A735-01-801. The pump will start to lose its ability to reach the lowest ultimate pressure as the tip seals become worn out. The base pressure for a new nXDS pump is often measured at 10 mTorr or less when evacuating a good clean leak-tight vacuum chamber. If you notice that your base pressure is now only getting to 25 mTorr then the tip seal will likely need to be replaced. Please see the instructions shown in the tip seal replacement manual in our Downloads section below.

Works With All Edwards nXDs Series Dry Scroll Vacuum Pumps
  • Edwards nXDS6i
  • Edwards nXDS10i
  • Edwards nXDS15i
  • Edwards nXDS20i
  • Edwards nXDS6ic
  • Edwards nXDS10ic
  • Edwards nXDS15ic
  • Edwards nXDS20ic
  • Edwards nXDS6ir
  • Edwards nXDS10ir
  • Edwards nXDS15ir
  • Edwards nXDS20ir
Marca de agua con el logotipo de Ideal Vacuum
CONTACT US
Ideal Vacuum Products , LLC
5910 Midway Park Blvd NE
Albuquerque, New Mexico 87109-5805 USA

Phone: (505) 872-0037
Fax: (505) 872-9001
info@idealvac.com



Press ESC to Close


deepbox image 2
load time = 0.4707